Instruction 106-450010-29-08Copyright®2008by S&S Cycle, Inc.All rights reserved.Printed in the U.S.A.Installation Instructions: S&S®T111 Engin
5- Remove the transmission top cover. Remove theneutral indicator switch, vent line and fitting fromthe transmission top cover.6- Install the
12- Press the oil line retention plates into place untilthey seat. Install the two screws (5⁄16-18 x 3⁄4 buttonhead) through the oil l
12C- Oil recommendationsNOTES S&S®Cycle recommends the use of Mobil 1®V-TWIN 20W-50 synthetic oil in our engines. S&S Cycle recommends the u
9- Initial Start-Up And Engine Break-In NOTE - engines are designed for high performance and assuch are not as tolerant of inadequate
10- Tuning GuidelinesIgnition timing and carburetor jetting are responsibilitiesof the customer. If not thoroughly familiar with theseprocedu
15Torque Values Specification S&SSuggestionRocker box hardware 1⁄4” 120 in-lbs. Loctite®243Rocker box hardware 5⁄16” 18 ft-lbs. Loctite 243Tappe
161. Bolt, stator 10-24 x1” SHC - 4 required(H-D#2720)(10 Pack) ...50-01942. Seal, sprocket shaft (H
2SAFE INSTALLATION AND OPERATION RULES:Before installing your new S&S part it is your responsibility to read andfollow the installation and ma
1- IntroductionS&S®T111 Engines are designed and intended forinstallation in a stock Harley-Davidson®Twin Cam 88®chassis. It will bolt
2- Additional Features: Greater overall strength than stock crankcases, especiallyin the front motor mount, an important consideration inhigh perfor
53- Modification NotesS&S®Cycle cautions against modifying these crankcasesdue to the possibility of damaging or weakening them.Modif
65- Ignition System InstallationA- All Carbureted S&S T111 assemblies come with an S&SIST (Intelligent Spark Technology) ignition. Use of this
7- Oil Line InstallationA- For 1999-2006 Harley-Davidson®FL models Oil line installation is crucial to engine life. If you are not surethat you can p
7- Mount the oil line block on the crankcase using 5⁄16-18 x 13⁄4” long screw (S&S®PN 50-0437)—do not finaltighten as it will be removed again.8-
91- Block, Oil line ...............106-11682- BHSHCS, 5⁄16-18 x 13⁄4 (10 pack) .......
Comments to this Manuals