Ss-cycle T111 Engine Assembly User Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
- Oil Line Installation
A- For 1999-2006 Harley-Davidson
®
FL models
Oil line installation is crucial to engine life. If you are not sure
that you can properly perform this operation, please contact
the S&S Tech Department for a referral to a shop in your area.
NOTE- Installation instructions are based on an engine and
transmission already in the chassis.
NOTE- Apply thread sealant to all tapered pipe threads.
1- Remove the stock oil supply and return fittings
from the transmission.
2- Install two supplied
3
8 NPT pipe plugs (S&S PN 50-8330)
in the oil fitting location.
NOTE- Apply thread sealant to all tapered pipe threads.
3- Remove crankcase vent fitting (S&S
®
PN 50-0451)
and set aside for later use. Install supplied vent
fitting (S&S PN 50-0449 is for use with 2002-’06 with
7
16 ID vent hose or 50-0454 for use with 1999-’01
with
3
8 ID vent hose) with O-ring installed on fitting.
See Picture 1.
4
- Install the vent hose and clamp (S&S PN 50-8156 or
50-8076-S) on the new fitting.
NOTE- The stock vent hose is reused in this step.
5- Position a drain container in front of the oil pan.
Next, locate and remove the two plugs on the
forward face of the oil pan allowing the oil to drain.
Once the oil is completely drained, replace the
3
8
p
ipe-plug with a 90-degree fitting (S&S PN 50-8288).
Position barb of fitting toward right side of bike at
an angle slightly above horizontal as shown in
Picture 2. Next, install the oil return fitting (S&S PN
50-0451) with O-ring (S&S PN 50-8008) in the drain
plug location.
6- Remove cover plate that was shipped on crankcase
from the bottom surface of the rear motor mount.
The oil line block will be installed in this location.
Assemble the oil line block by installing the 90-
degree fitting (S&S PN 50-8288) and the oil return
fitting (S&S PN 50-0451) with O-ring (S&S PN 50-8008)
into the block, as shown in Picture 3.
7
CAUTION
FL Oil Line Install Kit (PN 31-0425)
Picture 1 (2002-’06 Shown)
Picture 2
Picture 3
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments