8
3- Turn on the ignition switch and conrm the engine cut o switch is in the run position. Rotate the ignition module back and forth SLOWLY
until the red LED turns on. Once the light is on, rotate the module CLOCKWISE until the light just goes out. The light goes out when the
module is at TDC.
4- Use blue threadlock and tighten the standos (12-20 in-lbs) to secure the module in its proper timing position. Turn the ignition o and put
the spark plugs in.
GENERAL SYSTEM NOTES:
1- The S&S® Super Stock® Ignition requires the use of a 3 OHM single-re coil like the S&S coil PN 55-1571.
2- S&S recommends spiral core spark plug wires. Do not use solid copper or non-resistor plug wires.
3- S&S recommends Champion RN12YC (14mm) or Champion RA8HC (12mm) spark plugs gapped at .038” to .042”.
4- The VOES must be installed and wired for proper installation. When the VOES is activated, the green LED light in the module will illuminate.
5- Dealer software for engine diagnostics is available through the S&S website, www.sscycle.com or through your customer service representative.
6- S&S recommends using 91 or higher octane fuel.
7- Ignition systems for shovelhead style S&S engines are kick start compatible.
These charts may be used to ensure your module is correct for the application, and may be used to order replacement modules and kits.
Picture 8
S&S® SUPER STOCK® IGNITION KITS AND REPLACEMENT PARTS FOR S&S AFTERMARKET® ENGINES
Application Factory Module Replacement Module Ignition Kit*
S&S 80” Alternator/Generator shovelhead 55-1240B 55-1240 55-1250
S&S 93” Alternator/Generator shovelhead 55-1241B 55-1241 55-1251
S&S 93” HC Alternator/Generator shovelhead 55-1242B 55-1242 55-1252
S&S 103” Alternator/Generator shovelhead 55-1243B 55-1243 55-1253
S&S 96” V96 55-1244B 55-1244 55-1254
S&S 113” V113 55-1245B 55-1245 55-1255
S&S 124” V124 55-1246B 55-1246 55-1256
Kit contains S&S Super Stock module with hardware, pick-up cup and mounting screw, VOES switch with hardware, connectors and instructions. Replacement
modules do not have break-in rev limiter activated.
S&S® SUPER STOCK® REPLACEMENT MODULES FOR S&S EMISSIONS CERTIFIED ENGINES
Application Factory Module Replacement Module
S&S 3
5
/8” V-Series 55-1264B 55-1264
S&S 4” V-Series 55-1265B 55-1265
S&S 4
1
/8” V-Series 55-1266B 55-1266
Replacement modules do not have break-in rev limiter activated.
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals